Important Guide to Remove Epson WP-4540 Print

 Epson WP-4540 is a decent printing device which has been sitting in storage for a considerable length of time and scarcely shows any problems. It normally shows issues if you don't deal with it appropriately and utilizing it with no support over a significant stretch of time.

In the event that you have tried to clean it and still a couple of heads are clogged, try to wet the printhead with cleaning liquid. If it doesn't work out for you, take the Epson Printer Customer Support guide for performing deep cleaning.

 

·         Unplug The Power Supply 

The printer device will keep the cartridge from moving unreservedly and raise a white lock when you open the cartridge entryway. Thus, you have to unplug the power supply before the lock is set up. Disconnect the power supply quickly after opening the cartridge door to ensure that the cartridge gathering can be moved freely. 

·         Take Out the Top Panel

There will be a white knob on the left corner and close to that there will be a hole. Discover it, tap in with your finger to pop up the top cover. Repeat the steps to the right hand side. On the front, there will be 3 screws, remove them. Presently you will see two wires: a red or dark black door trigger wire and a black ground wire. Likewise, there will be an electronic strip. Disengage wires just as electric ribbon and connect them back. 

·         Unscrews the Back of the Printer Device

Go to the back of the printer, and unscrew top 2 screws and afterward bottom 2 screws of the back wire plate. 

·         Unplug Wires from the Back of Your Printer

There will be many wired mixes so it is advised to snap a photo with respect to the wire bundles to avoid any problems and set them back in succession. Make a checklist from the start to finish: pull out four white or gray, three dark, three black, two red and 2 black wire packages and afterward unscrew 1 dark ground wire. 

·         Remove the Back Plate

Separate the top unit from the rest of the printer device. Go to the printer back and unscrew the 4 screws which are holding the box cover.

 ·         Remove The Box Cover & Cartridge Door

Go to the front of the printer device and on the front cartridge box, remove 2 screws and the take out one screw at upper right. Presently remove the cartridge door. There will be two additional screws holding the box spread, remove these 2 screws likewise and remove the box.

There will be 2 screws holding ink tubes and four electronic strips, clear out them and afterward expel four additional screws to take the printhead out.

In case if you need any further guidance to take the printhead out, you can ask our tech professionals to get the Epson Printer Support Number.